tag:blogger.com,1999:blog-4436082279489369797.post8523265220262751585..comments2024-03-28T08:24:06.785+01:00Comments on Andersen leather : GussetMr. Andersenhttp://www.blogger.com/profile/05628988180796422542noreply@blogger.comBlogger5125tag:blogger.com,1999:blog-4436082279489369797.post-58207322386373856292016-11-02T15:12:06.759+01:002016-11-02T15:12:06.759+01:00This specification to the first question)) Thank y...This specification to the first question)) Thank you! Very helpful! Anonymoushttps://www.blogger.com/profile/06015056755750447878noreply@blogger.comtag:blogger.com,1999:blog-4436082279489369797.post-58556309859235202842016-11-02T14:55:26.166+01:002016-11-02T14:55:26.166+01:00I dont understand the question :)I dont understand the question :)Mr. Andersenhttps://www.blogger.com/profile/05628988180796422542noreply@blogger.comtag:blogger.com,1999:blog-4436082279489369797.post-36556779583417934042016-11-02T14:54:47.436+01:002016-11-02T14:54:47.436+01:00Hi,
I just calculated how long the gusset needed ...Hi, <br />I just calculated how long the gusset needed to be in order to fit the panel. I however forgot to take the rounding of the panel corners into account. This means that the current pattern is not 100% correct. <br />Where it says 30 cm it should instead be 29,7cm and where it says 42 cm it should be 42,4. These are the correct measurements providing that your panel is 43 cm x 30 cm with corner radius of 1,4cm<br />Mr. Andersenhttps://www.blogger.com/profile/05628988180796422542noreply@blogger.comtag:blogger.com,1999:blog-4436082279489369797.post-51148646859103995632016-11-02T14:51:08.180+01:002016-11-02T14:51:08.180+01:00If to look at your photo, then length between base...If to look at your photo, then length between bases of the trianglesAnonymoushttps://www.blogger.com/profile/06015056755750447878noreply@blogger.comtag:blogger.com,1999:blog-4436082279489369797.post-54020840229454068652016-11-02T14:35:26.821+01:002016-11-02T14:35:26.821+01:00Hi,
Did you first make a gusset, then cut the pane...Hi,<br />Did you first make a gusset, then cut the panels for the gusset size? Or how do you determine the distance where beginning of the vertical bends of the one and the other side, if panels are cuts first? Thank you! Anonymoushttps://www.blogger.com/profile/06015056755750447878noreply@blogger.com